5 - MAINTENANCE INSTRUCTIONS
5 - MAINTENANCE INSTRUCTIONS
6.Lock the ends of the line in opposite slots on the spool (Fig.
7.Insert the line through each eyelet in the spool carrier and slide the spool into the carrier. (Fig.
8.Make sure to insert the spring, assemble the spool and spool carrier back onto the trimmer. To do so, push the head on and turn it clockwise until it locks. (Fig.
9.To test if the line is advancing properly, push the but- ton with your thumb while pulling the line with your fin- gers. The line should advance freely. (Fig.
10.In the event of the line breaking inside the spool, repeat the replacement operation.
11.Start the grass trimmer following the instructions in the “STARTING” section.
5-2. MAINTENANCE
WARNING
Before doing maintenance operations disconnect the power supply by unplugging the extension cord.
1. | Regular cleaning and maintenance of your string trim- |
| mer will ensure efficiency and prolong the life of your |
| machine. |
2. | After each cutting operation, take apart and clean out |
| the grass and soil from: the spool and its slot and in |
| particular the debris shield. |
3. | During operation, keep the air slots clean and free of |
| grass. |
4. | Only use a cloth soaked with hot water and a soft |
| brush to clean the string trimmer. |
5. | Do not spray or wet the appliance with water. |
6. | Do not use detergents or solvents as these could ruin |
5-1F
5-1M
the trimmer. The parts made of plastic can easily be |
damaged by chemical agents. |
7. If the line cutting line no longer cuts or breaks, have |
this replaced by contacting an authorized service |
centre. |
10
11