Specifications

Specifications

Power Output

Minimum sine wave continuous average power output per channel, all channels operating is:

200 watts into a 4 ohm or 8 ohm load

Rated Power Band

20Hz to 20,000Hz

Total Harmonic Distortion

Maximum Total Harmonic Distortion at any power level from 250 milliwatts to rated power output is: 0.005% for 4 or 8 ohm loads

Dynamic Headroom 1.7dB

Frequency Response

+0, -0.25dB from 20Hz to 20,000Hz +0, -3dB from 10Hz to 100,000Hz

Sensitivity

1.0Volt Balanced with a 4 ohm Loudspeaker

2.0Volt Unbalanced with a 4 ohm Loudspeaker

1.4Volt Balanced with a 8 ohm Loudspeaker

2.8Volt Unbalanced with a 8 ohm Loudspeaker

A-Weighted Signal To Noise Ratio

89dB (112dB below rated output)

Intermodulation Distortion

Maximum Intermodulation Distortion if instanta- neous peak output per channel does not exceed twice the rated output, for any combination of fre- quencies from 20Hz to 20,000Hz, with all channels operating is:

0.005% for 4 or 8 ohm loads

Input Impedance

20,000 ohms Balanced

10,000 ohms Unbalanced

Wide Band Damping Factor

Greater than 60 at 4 ohms

Greater than 140 at 8 ohms

Power Requirements

100 Volts, 50/60Hz at 14.4 amps

110 Volts, 50/60Hz at 13.0 amps

120

Volts, 50/60Hz at 12.0 amps

220

Volts, 50/60Hz at

6.0 amps

230

Volts, 50/60Hz at

6.0 amps

240

Volts, 50/60Hz at

6.0 amps

Note: Refer to the rear panel of the MC207 for the correct voltage.

Overall Dimensions

17-1/2 inches (44.45cm) W, 9-7/16 inches (23.97cm) H, 18-3/4 inches (47.63cm) D, including clearance for con- nectors

Weight

83 pounds (37.6 kg) net, 116 pounds (52.6 kg) in shipping carton

22

Page 22
Image 22
McIntosh MC207 owner manual Specifications