How to Connect for Stereo
Caution: The supplied AC Power Cord should not be connected to the Rear Panel of the MC2102 Amplifier until after the Loudspeaker Connections have been made and the supplied protective Terminal Connections Cover has been installed. Failure to observe this could result in Electric Shock.
1.For Remote Power Control, connect a power control cable from the Control Center or Preamplifier Power Control Out to the MC2102 Power Control In.
2.Connect cables from the Balanced Outputs of a McIn- tosh Preamplifier or Control Center to the MC2102 Left and Right Balanced Inputs.
Note: An optional hookup is to use unbalanced cables.
3.Prepare the Loudspeaker Hookup Cables that attach to the MC2102 Power Amplifier Output Terminals by choosing one of the methods below:
Bare wire cable ends:
Carefully remove sufficient insulation from the cable ends, refer to figures 8, 9 & 10. If the cable is stranded, carefully twist
the strands together as tightly as possible.
Note: If desired, the twisted ends can
be tinned with solder to keep the strands together, or attach spade lug and/or banana connector.
Spade lug or prepared wire connection:
Insert the spade lug connector or prepared section of the cable end
into the terminal
side access hole,
and tighten the terminal cap un-
til the cable is firmly clamped into the terminal so the wires cannot slip out. Refer to figures 11, 12 & 13. Banana plug connection:
Insert the banana plug into the hole at the top of the ter- minal. Tighten the top portion of the terminal post to secure the banana plug in place.
Note: The use of Banana Plugs is for use in the United States and Canada only.
4.Locate the Terminal Connec- tion Cover and pass the Loud- speaker Hookup Cables thru
the Loudspeaker Cable Openings located near the top of the Terminal Cover.
5.Connect the Loudspeaker Hookup Cables to the output terminals that match the impedance of your loudspeak- ers, being careful to observe the correct polarities. Out- put impedance connections of 2 ohm, 4 ohm and 8 ohm are provided. If the impedance of your loudspeakers is
WARNING: Loudspeaker terminals are hazardous live and present a risk of electric shock. For additional instruction on making Loudspeaker Connections contact your McIntosh Dealer or McIntosh Technical Support.
6.Remove the three Phillips Head Mounting Screws (10- 32 x 1/2 inch) from the Rear Panel of the MC2102. Re- fer to figure 14.
7.Place the Terminal Connection Cover over the top of the RIGHT and LEFT OUTPUT Terminal Connectors.
Note: Any excess of Loudspeaker Hookup Cable may be pulled back thru the Terminal Connection Cover, which will aid in seating the cover to the Top Rear of the Chassis.
8.Attach the supplied Terminal Connections Cover with the three Phillips Head Mounting Screws
9.Rotate the MC2102 POWER SWITCH to the OFF Po- sition and connect the supplied power cord to an active AC outlet.
Cable Openings
Terminal
Connections
Cover
Cover |
| Mounting | Figure 14 |
| |||
Screw Locations |
|
10