How to Operate in Four or Three Channel Mode
How to Operate Four Channel Mode | How to Operate Three Channel Mode | |
|
|
|
|
|
|
In the Four Channel Mode, all channels operate as inde- pendent 50 watt amplifiers. A typical four channel applica- tion is to drive a pair of full range loudspeakers in the front section of a vehicle and a second pair in the rear. Refer to figures 7 and 8.
Power
The MCC204 will turn On or Off when the Control Center turns On or Off.
Note: There must be an Amp ON connection between the MCC204 and the signal source unit in order for the amplifier power turn On and Off to function.
In the Three Channel,
Power
The MCC204 will turn On or Off when the control center turns On or Off.
Note: There must be an Amp ON connection between the MCC204 and the signal source in order for the amplifier turn On and Off to function.
Input Source
Set the Input SOURCE Switch to the 3, 4 position for 4 Channel Mode.
Sensitivity Controls
The Sensitivity Controls allow setting of the input level of all four amplifier channels to provide an ideal match for the signal source being used.
Mode
Set both MODE Switches to the STereo position to config- ure the amplifier for four channel operation.
Crossover
Set the CROSSOVER Switches to the OUT position since all channels are operating at full frequency range.
Input Source
Set the Input SOURCE Switch to 3, 4.
Sensitivity Controls
The Sensitivity Controls allow setting the input level of amplifier channels 1, 2 and 3 to provide an ideal match for the signal source being used. Sensitivity Control 3 adjusts the woofer level balance and Sensitivity Control 4 has no effect.
Mode
Set the Channels
Crossover
Set the CROSSOVER Switches to the OUT position since all channels are operating at full frequency range.
Figure 7
Figure 8
14
