How to Prepare Hookup Cables
The McIntosh XRT28 Loudspeaker System utilizes bind- ing posts for speaker wire connections. Prepare the Loud- speaker Hookup Cables that attach to the Power Amplifier Output Terminals:
Bare wire cable ends:
Carefully remove sufficient insulation from the cable ends, refer to figures 19, 20 & 21. If the cable is stranded, carefully twist the strands together as tightly as possible.
Note: If desired,
the twisted ends can be
tinned with
solder to keep the
strands together and/or attach a spade lug.
Spade lug or prepared wire connection:
Insert the spade lug connector or prepared section of the cable end into the terminal side access hole, and tighten the terminal cap until the cable is firmly clamped
into the terminal so the
wires cannot
slip out. Refer to figures 22, 23 & 24.
5.Connect a Loudspeaker cable from the Positive (+) Binding Post of the Amplifier Number Two to the XRT28 Loudspeaker System MID 4S (+) Binding Post.
6.Tighten all of the Loudspeaker and Amplifier Binding Posts.
McIntosh Single Channel Amplifier Number Two
How to Connect using two Amplifiers
1.Remove jumpers between the MID and LOW COMmon
(+) Binding Posts. The removed jumpers should be re- tained for possible future use.
McIntosh Single Channel Amplifier Number One
Note: For Midrange and High Frequency operation, jumpers must be in place between the MID and HIGH COMmon
2.Connect a Loudspeaker cable from the Negative
3.Connect a Loudspeaker cable from the Positive (+) Binding Post of the Amplifier Number One to the XRT28 Loudspeaker System LOW 4S (+) Binding Post.
4.Connect a Loudspeaker cable from the Negative
12
