Fig 10. Focus knob.
Fig 11. Insert batteries.
Fig 12. Plug AutoStar into the HBX port of the computer control panel.
Fig 13. Thread the dust cover onto the tube.
Fig 14. The dewshield.
Fig 15. Secure the telescope in the backpack using the velcro strap.
10.Secure the eyepieces in place with their respective thumbsrews.
Tip: Always start observing using a low power eyepiece to get a nice wide field of view. Later on you can change to high power, if so desired. But high powered eyepieces have a much narrower field of view and it’s more difficult to locate objects using high powered eyepieces.
11.You can focus the eyepieces by turning the focus knob.
Tip: The focus knob has a very fine focus, so you may have to turn the knob 20 com- plete turns or more to focus on an object.
Connect the AutoStar Handbox
12.Lift the battery cover. Now gently remove the battery holder from the compartment so you don’t accidentally pull out the wires attached to the holder. Insert 6 user supplied “AA” batteries in the holder. Refer to the diagram on the holder to orient the batteries properly. Replace the holder back into the battery compartment and replace the lid.
13.Make sure that the computer control panel power switch is in the OFF position. Remove AutoStar from the packing materials and plug it into the HBX port.
14.Flip the Power Switch on the computer control panel to the ON position. The copyright message lights on AutoStar’s LCD display.
15.Press the key prompted by AutoStar to accept the Sun warning.
Stowing your Gear in the Backpack
First disassemble the telescope assembly.
1.Loosen the vertical lock. Now move the tube to an upright position so that it is pointing straight up through the fork arms and
2.Loosen the bolts on the underside of the tripod base, rotate the telescope counterclock- wise, and lift the telescope off of the tripod. Now remove the bolts from the base.
3.Unscrew the dew shield. Thread the dust cover over the end of the telescope. Then flip the dewshield over and place it over the end of the tube.
4.Next, close and lock the tripod: Hold the tripod by its handle and turn the locking ring to loosen the tripod mechanism.
5.Lift the locking ring as far as it will go. Turn the locking ring to tighten the tripod in place.
Caution: Be careful not to close the tripod legs on your fingers. Now, place the accessories and telescope into the backpack.
6.Put the eyepiece container into the provided pouches in the accessory compartment with the “lip” at the top.
7.Place the bolts, prism into their respective pouches. Zip up the accessory compartment.
8Stow the ETX telescope in your backpack. Use the velcro tape inside of the backpack to
further secure it in place. Place the AutoStar handbox into the lower section of the pack.
9.Zip up the pack.
10.Slide the tripod under the loops on the pack so that the feet will face downward when you carry the pack. Secure the tripod using the loop lock: Hold the knot with one hand and move the lock down toward the tripod with your other hand.
Safety Precautions
•Take care not to allow the telescope to be jolted severely while hiking.
•Try not to run for any significant distance. Don’t toss the telescope in the pack on the ground. Excessive vibrations may damage the telescope.
•The backpack is made of
telescope.
14
