NOTE:
AutoStar requests the Country/State, City, and Telescope Model information only the first time AutoStar is activated. If you wish to change this informa- tion, use the "Site" and "Telescope Model" options in the Setup menu.
Observe the Moon
Point your telescope at the Moon (note that the Moon is not visible every night) and practice using the Arrow keys and the slew speeds to view different features. The Moon contains many interesting features, including craters, mountain ranges, and fault lines. The best time to view the Moon is during its crescent or half phase. Sunlight strikes the Moon at an angle during these periods and adds a depth to the view. No shadows are seen during a full Moon, causing the overly bright surface to appear flat and rather uninteresting.
Consider the use of a neutral density Moon filter when observing the Moon. Not only does it cut down the Moon's bright glare, but it also enhances contrast, providing a more dramatic image.
To Track an Object Automatically
As the Earth rotates beneath the night sky, the stars appear to move from East to West. The speed at which the stars move is called the sidereal rate. You can setup your telescope to move at the sidereal rate so that it automatically "tracks" the stars and other objects in the night sky. In other words, if the telescope is not tracking an astronomical object, the object will drift out of the eyepiece field of view. The tracking function automatically keeps an object more or less cen- tered in the telescope’s eyepiece.
To track objects, you must first initialize AutoStar and then select "Targets: Astronomical" from the AutoStar Setup menu. You must also learn how the AutoStar keypad operates in order to move through the AutoStar menus.
Moving Through AutoStar’s Menus
The AutoStar database is organized in levels for quick and easy navigation.
•Press ENTER to go deeper into AutoStar's menu levels.
•Press MODE to move back toward the top menu level.
•Use the Scroll keys to move up and down through the options available for each level.
•Use the Scroll keys to enter characters and digits.
The Arrow keys are used to move the telescope, and can also enter numbers and letters.
Initializing AutoStar
This section describes how to initialize AutoStar. Perform this procedure the first time you use AutoStar or after performing a RESET.
1.Secure the locks: Make sure that the vertical and horizontal locks (13 and 14, Fig. 1) are secured.
2.Plug in AutoStar: Connect AutoStar to the HBX port of the computer control panel (16a, Fig. 1B).
3.Turn on the control panel: Flip the telescope power switch of the computer control panel to the ON position.
The AutoStar screen is activated and a copyright message displays briefly, followed by a short beep. Then AutoStar takes a few moments to start up the system.
4.Sun Warning: A message displays that warns not to look at the Sun. At the end of this message, press the Speed/? key to signify that the message has been read and understood.
5.Getting Started: The Getting Started menu displays a scrolling message. Press ENTER (2, Fig. 5) to bypass the Help tutorial and continue with initialization.
6.Daylight Savings Time: The next screen requests the status of Daylight Savings Time. Press one of the Scroll keys to toggle between the YES/NO settings. When the desired set- ting displays, press ENTER.
Note: When multiple choices are available within a menu option, the option that is currently enabled is usually displayed first and highlighted by a right pointing Arrow
(>).
17
