CHANGING PRESSURE AND ALTITUDE UNITS
•Press MODE as needed, until “LOCAL” pressure is displayed.
•Press and hold HISTORY, until the pressure unit is flashing.
•Change local or sea level pressure units by pressing the UP (? ) or DOWN (? ) buttons to select the pressure units. Choose from: inHg, hPa/mBar or mmHg.
•Press HISTORY to confirm your selection.
•Press MODE button until the local altitude value will be displayed.
•Press and hold HISTORY until the altitude unit is flashing.
•Select the ALTITUDE unit:, meters or feet, by pressing UP (? ) or DOWN (? ) buttons.
•Press HISTORY to confirm your selection.
VIEWING SEA LEVEL PRESSURE HISTORY
•In pressure mode, press HISTORY button entering the sea level pressure display.
•When the SEA LEVEL is displayed, press HISTORY repeatedly viewing the sea level pressure history for the past 24 hours in 1 hour intervals.
•If no buttons are pressed for 5 seconds, the unit will automatically return to the default Pressure and Weather Forecast Mode.
VIEWING PRESSURE, TEMPERATURE AND HUMIDITY CHARTS
The bar chart in Pressure Window can be configured to display a historical data for the sea level pressure and temperature or humidity for channel 1.
After selecting the Pressure Window, press and hold ALARM button to toggle the bar chart between the sea level pressure with a word “PRESSURE” displayed at the right bottom corner of the chart, temperature with a thermometer icon and “CH1” and a humidity with “RH” icon and “CH1”.
MOON PHASE ICONS
New | Waning | First | Waxing | Full | Waning | Last | Waning |
Moon | Crescent | Quarter | Gibbous | Moon | Gibbous | Quarter | Crescent |
TEMPERATURE/ HUMIDITY WINDOW
The main unit supports up to 3 remote sensors, corresponding to a separate channel of the temperature and relative humidity display. The temperature can be displayed in Celsius (ºC) or Fahrenheit (ºF).
The main unit carries the temperature and humidity sensor and uses this data to calculate an indoors comfort level - Wet, Comfort or Dry.
A temperature alert function is available for all channels. It can be programmed to sound if the channel temperature exceeds or falls below the
10
