REMOTE SENSORS STATUS
The wave icon above the current channel icon shows the connection status of the corresponding remote sensor:
Icon | Status |
Searching for the signals from the remote sensor
Corresponding remote sensor signal received successfully
No signals received for over 1 hour
SEARCH FOR REMOTE SENSORS
•The main unit can be manually activated to search for the signals from remote sensors by pressing and holding DOWN (? ) button.
OPERATION
•To select the indoor/ outdoor temperature mode, press UP (? ) or DOWN (? ) until the IN icon 
flashing with a beep sound alert.
VIEWING REMOTE (CHANNEL) TEMPERATURE AND HUMIDITY
Static Display:
•Press the CHANNEL button to select measurements from different remote sensors, each is set to a unique channel 1, 2 or 3.
Channel
•To enable an automatic scan of all channels, press and hold CHANNEL, until the 
icon is displayed. The measurements from each remote channel will be alternately displayed with a 5 seconds viewing.
NOTE: the channel
PROGRAMMING TEMPERATURE IN CELSIUS OR FAHRENHEIT
•Press and hold MODE button for 3 seconds to toggle the temperature unit in Celsius (ºC) or Fahrenheit (ºF).
SETTING TEMPERATURE ALARM
•Press 
down button to select temp display.
•Press TEMP ALARM button selecting the desired alarm, the upper temperature alert with 
icon (if disabled, displays OFF), or lower temperature alert with 
icon (if disabled, displays OFF).
•Press and hold TEMP ALARM button until the temperature digits flashing.
•Adjust the temperature digits using the UP (? ) or DOWN (? ). Press and hold either button for fast digits advance
•Press the TEMP ALARM to confirm selection and return to the temperature alarm selection screen
ACTIVATING OR DEACTIVATING TEMPERATURE ALARMS
•Once the above alerts are displayed, press the UP (? ) or DOWN (? ) to enable or disable the corresponding alert.
11
