Meco 2200 Troubleshooting, Grill Moving and Storage, Burner will not light using the ignitor

GRILL MOVING AND STORAGE

·Do not store the Grill unless it has cooled down and has been cleaned.

·Always Lock the Grill Hood with the Strap Lock before moving and storing this Grill.

·To avoid possible injury, be careful when rolling your grill so it does not roll up against you.

Your Gas Grill comes with convenient wheels and a slide out handle for roll-away transport. When the Grill has completely cooled, and the Grill and all the parts are clean:

·Disconnect the LP cylinder from the regulator.

·Fold and strap the Grill side tables over the closed Hood.

·Slide the Left Handle Bar back under the grill.

·Remove the leg shelf. Release the locking springs and lower the left end of the Leg Shelf. Lift the other end off the mounting Hooks on the right legs.

·Swing the Gas Regulator up into its storage position behind the front panel of the Grill and clip it into place.

(FIG. 24)

·Fold Legs to locked position under Grill.

·Store Leg Shelf back in the bottom of the grill and snap into place.

·Grasp the Right side Handle Bar; lift Grill on wheels and roll the grill away to storage area. (FIG. 25) DO NOT

ATTEMPT TO CARRY THE GRILL BY GRASPING THE HOOD HANDLE

Store Gas Regulator & Hose

Fig. 24

Storage Clip

Use Slide Handle

Bar for Towing

Tow-away on Wheels

For Convenient Storage

Fig. 25

TROUBLESHOOTING

Problem

Burner will not light using the ignitor

Possible Cause	Solution
Not pausing long enough	When lighting the Burner, push in and turn the Control Knob
before clicking the Igniter	counterclockwise to “I” when you feel resistance. Pause 4
	seconds, then push in and turn the Control Knob until a click is
	heard.
No spark	The spacing between electrode and Burner ports should be
	approximately 3/16”. Make sure wire connections are secure
	and burner is attached securely to brackets.
LP gas cylinder is empty	Dispose of empty cylinder and replace with a full one.
Excess flow valve tripped in	Turn Control Knob to “OFF” position. Wait five minutes. Relight
Regulator	LP gas grill. If flame remains to be low, turn off gas.
	Disconnect the Lp gas cylinder from the Regulator. Reconnect
	the LP gas cylinder to the Regulator. Perform a leak test.
	Relight grill. This will reset the excess flow valve.

Obstructions in burner

Electrode and burner are wet

Wire is loose or disconnect-

Wire is shorting (sparking between ignitor wire and electrode

Burner not assembled correctly

Clean burner (See Burner Maintenance in Care and Maintenance section of this manual)

Dry electrode with clean cloth

Reconnect the wire

Replace ignitor wire/electrode assembly (Call the Customer Service Department @ 1-800-251-7558)

See Assembly Instructions for installing the Burner.

13