Meco 4280 Walk-a-bout manual Lighting the GAS Grill, Ignition Lighting the Grill

5a) If using a 20 lb. cylinder, turn cylinder handle counterclockwise to “On”.

Check for leaks around

Cylinder Coupling Nut

5b) Check for leaks around Adapter Hose to Regulator Connection.

5c) If a leak appears at the 20 lb. cylinder/adapter hose connection or adapter hose/regulator connection, unscrew the hose and retighten, but do not overtighten. (Note: Only hand tighten. Do not use any tools) Repeat Leak Test. If a leak cannot be stopped, disconnect the LP cylinder and Do not use the grill. Call Customer Service at 1-800-251-7558.

6)Upon completion of leak test:

A) Disconnect LP cylinders from the regulator control. B) Turn 20 lb. cylinder valve clockwise to the “Off”

position.

7) Place the protective cap over the LP cylinder gas nozzle. Store the cylinder in a safe place.

If no leaks are found, the grill is ready to use.

LIGHTING THE GAS GRILL

IGNITION LIGHTING THE GRILL

To reduce the risk of serious bodily injury or death:

·Open Hood and all vents before lighting the grill to prevent an explosion from gas build-up.

·Make sure there are no obstructions to the flow of combustion and ventilation air to the grill burners.

·During failed lighting attempts, or a burner goes out during the cooking process; turn control knob “Off” to dissipate any accumulation of gas. Wait five minutes before repeating lighting procedure.

1)Attach LP cylinder. Open the top Hood vent, then open the Hood all the way.

2)Important: Make sure grill control knob is turned “Off” first.

3)If using a 20 lb. LP Cylinder, turn handle counterclockwise to “ON”.

4)Push in Control Knob and turn counter clockwise to the “High” position.

5)Push Ignitor button in several times to light the burner. Listen for the spark ignition and look to make sure all burner holes are lit. If no spark, see Troubleshooting Section and figure below.

3/16” Gap between electrode and burner

6)If Grill burner fails to light, repeat Steps 2-4.

If the burner fails to light after three or four attempts following Steps 2-5, turn control knob to the “Off” position. Wait five minutes; then repeat the lighting procedure. NOTE: If the burner still fails to light, refer to the Troubleshooting Section. The burner can also be lit manually, see Manual Lighting The Grill.

7)After ignition, install the Cooking Grid. Turn the control knob to “High” for 3-8 minutes and close the Hood to preheat the Cooking Grid and the grill. Preheat the grill before every cooking session.)

If the burner goes out during operation, turn the control knob to the “Off” position. Open hood and wait five minutes before attempting to relight the grill. If it does not relight, turn control knob to the “Off” position. Make sure there are no open flames nearby, then disconnect the cylinder and see if it is empty.

8