![](/images/new-backgrounds/1250569/25056939x1.webp)
20
Manually Lighting the Grill
!WARNING
To reduce the risk of serious bodily injury or death from fire or explosion:
• Open Hood before lighting the grill to prevent an explosion from gas
1.Open the Hood.
2.IMPORTANT: Make sure Control Knobs are turned “Off.” (Fig. 7 - P.18)
3.Turn the LP Gas Cylinder valve open counterclockwise until it stops. (Fig. 8- P.18)
4.Locate either the left or right
5.Insert a lit match through the
View from underneath. Insert lit match through matchlighting hole under the left side burner table using the match light holder
Fig. 11
View of match through hole from top side of burner. Shown without Flavor Activators and
cooking grids.
Fig. 11a
View of inserting lit match through the cooking grids. Each burner may be lit in succession in this method if necessary.
Fig. 12
6.From the “Off” position, light all other Burners from left or right, making sure each Burner is lit before lighting the next. Your grill has a Crossover Ignition System that allows the Burners to light successively off one another. Confirm each Burner is lit before lighting another Burner.
If any or all Burners fail to light after three or four attempts following Steps
NOTE: If the Burner still fails to light, refer to the Troubleshooting Section.
7.After ignition, turn the Control Knobs to “High” for
If a Burner goes out during operation, turn all Control Knobs to the “Off” position and close the LP Gas Cylinder valve to dissipate any accumulated gas. Open Hood and wait five minutes before attempting to relight the grill.