•The nozzles are to be used as follows:
Floor nozzle | Floors (brushes out) |
| Carpets (brushes in) |
Combination nozzle | Radiators, corners, |
skirtings, etc. |
|
Combination nozzle | Furniture, curtains, |
extended (19a) | drapes, books, frames, |
| etc. |
•The floor nozzle has two settings. When cleaning hard surfaces (parquet flooring, flooring tiles, etc.), the nozzle brushes should be extended. When cleaning carpets and rugs, the brushes should be retracted into the nozzle. Press the brush change button (1a) to switch between the two settings.
•If, during vacuuming, you need to pause to move furniture etc., you can place the floor nozzle in the parking holder (14) using the fixture on the back of the nozzle.
FILTERS
This vacuum cleaner is not equipped with a dust bag. The dust/dirt is sucked up into the transparent dust container (8) instead. Once the dust is in this container, it whirls around so that it does not block suction. The air sucked in is cleaned by means of a washable permanent filter in the dust container, a motor protection filter and an exhaust filter.
Important!
You must never vacuum without all three filters or when a filter is damaged. If you do, dust may penetrate into the interior of the vacuum cleaner and damage the motor.
Emptying the dust container and cleaning the permanent filter
It is easy to see when the transparent dust container needs emptying.
1.Turn off the vacuum cleaner, and remove the plug from the wall socket.
2.Check whether the dust container is full, using the window (18).
3.Remove the dust container from the vacuum cleaner by pressing the release button (9) and lifting the handle on the dust container (see image on the right).
1.Take the dust container to a dustbin.
2.Turn the upper section of the dust container anticlockwise, so the
3.Lift the upper section off the lower section, and empty the container.
4.Turn the permanent filter clockwise, remove it from the upper section and tap it gently. (We recommend that you do this while holding the filter in a bag).
20
