Mellerware 26602 Kibbeh accessory M, Reverse Function, Once you have finished using the appliance

edge of the mincing head (fig. 5).

-Insert the sausage accessory through the locking rim (fig. 7).

-Screw the lock rim tightly onto the outlet mouth of the mincing head, turning clockwise to secure the endless screw, cutting blades and the cutting plate (fig. 6).

-Position the tray at the top of the mincing head.

Kibbeh accessory (M)

-Press & hold the lock button while inserting the mincing head (fig. 1). Then turn the mincing head anti-clockwise until the chute is vertical. Release the lock button to secure the mincing head in position (fig. 2).

-Insert the endless screw through the outlet mouth of the mincing head (fig. 3).

-Insert the Kibbeh accessory base onto the endless screw and position the other Kibbeh accessory on top. Fit the bulges of the Kibbeh base in the notches of the filling mouth (fig. 8).

-Screw on the lock rim, turning clock-wise to secure the Kibbeh accessory onto the endless screw (fig. 9).

-Position the tray at the top of the mincing head.

Reverse Function:

-If food gets stuck, switch off the appliance. Press the I/ II knob and set to “II” position and ON/0/R switch to “R” position.

-The endless screw will rotate in the opposite direction and unclog the mincing head.

-If this doesn’t work, switch off the unit and clean it.

Once you have finished using the appliance:

-Turn the appliance off, using the on/off switch.

-Remove the plug from the wall socket.

-Clean the appliance.

Cleaning

-Clean the equipment with a damp cloth and a few drops of washing up liquid, and then dry.

-Do not use solvents, or products with an acid

or base pH such as bleach, or abrasive products, for cleaning the appliance.

-Never submerge the appliance, power cord or plug in water or any other liquid or place under running water.

-During the cleaning process, take special care with the blades, as they are very sharp.

-The following components may be cleaned in a dishwasher: tray, mincing head, lock rim, endless screw and cutting plates.

Anomalies and repair

-Take the appliance to an authorised technical support service center if any problems arise. Do not try to dismantle or repair without assistance, as this may be dangerous.

-If the plug has been damaged, it must be replaced and you should proceed as you would in the case of damage.

This appliance complies with Directive 2006/95/EC on Low Voltage and Directive 2004/108/EC on Electromagnetic Compatibility.

26602 IM.indd 5

24/08/2011 09:05:23