tal surface away from direct sunlight and sources of heat (stove, heater, radiator etc).
3.This table top water dispenser is not recom- mended for outdoor use.
4.NB: The water dispenser is
•Keep the dispenser unplugged
•Fill the water tank with tap water full to ca- pacity. Wait for 5 minutes until water settles.
•Proceed to drain the water from both faucets until no more water is remaining.
•Proceed to make sure both drain caps and faucets are closed.
•Place the water bottle on the water intake; allow water to stand approximately
one minute.
•Open water faucets to ensure water flows from both faucets.
•Plug the dispenser into the electrical outlet.
•Turn the cold and hot water switches ON
Trouble shooting guide:
(at the rear).
•Now you are ready to use your Table Top Hot and Cold Water dispenser.
Instructions for cleaning:
•Unplug the dispenser from the power outlet.
•The dispenser was disinfected before leav- ing the factory. You can use a fit for human consumption disinfector to clean
it after six months.
•It is advisable to take it in for service after 1 year in order to clean the heating pot. This must be done by a qualified technician.
•Care is needed when cleaning the appli- ance to ensure that water do not go into the electric power parts.
•Wash the inside of the reservoir with warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quarter of water.
•The drip tray and water faucets should be cleaned with mild detergent and warm water.
PROBLEM | SOLUTION |
|
|
Dispenser does not work properly or water | • Check if the appliance is plugged in |
does not flow out. | and switched on. |
| • Check if there’s water in the bottle |
| • Clear away any blockages in the reservoir. |
| • Check if the circuit break and see if not |
| tripped or a blow fuse. |
|
|
Water is not hot enough | • Check to see if hot water switch |
| is turned on. |
| • Too much hot water has been used in a |
| short period of time. Allow it a few minutes it |
| will heat up again. |
|
|
Water is not cold enough | • Check to see if cold water switch |
| is turned on. |
| • Too much cold water has been used in a |
| short period of time. Allow it a few minutes it |
| will heat up again. |
|
|
Vibrations | • Check to see that the water |
| dispenser is level. |
|
|
Leakage | • Check to see that the bottle is properly fitted |
| or change bottle if damaged. |
|
|
_IM.indd 3
1/28/2014 1:45:12 PM
