Use and function
A Guide to Assembling
Caution:
Be sure to cut off power and dismantle accesso- ries before assembling.
Join hose and cleaner by means of joining hose at suction inlet .
(Fig. 1)
Insert the hose into the suction and turn it clock- wise.
Assembling hose handle to extension tube:
To attach the hose handle to the extension tube, insert the bottom of the hose handle into the top of the extension tube (as shown in figure 2). The amount of suction may also be adjusted by using the air regulator vent on the hose handle.
(Fig. 2)
Control of suction force:
Caution:
Once all the accessories have been attached to the the appliance, remove the desired length of cord required. The yellow mark on the cord is the recommended ideal cord length. The cord should not be removed beyond the red mark.
1.Insert the power plug;
2.Press down the switch button of the cleaner, keep it ON ; make the suction power stronger by turning it clockwise and make weaker by turning it anticlockwise.
(Fig. 3)
Switch button | Cord rewinder |
| button |
VAC2000_IM.indd 4
3.Ideal cord reel method is as follows: Place plug in one hand and using the other hand, press cord reel button to rewind cord. By keeping the plug in one hand, this allows cord to be retract- ed properly and not allow cord to get tangled during rewind process.
4.Thermal
This appliance has been fitted with a thermal cut- out to protect the motor from destruction or harm, should the operating temperature exceed the safe operating temperature. If the appliance cuts out, re- move the plug from the socket and allow the appli- ance to cool down. Also check all piping and tubes for obsticles blocking or restricting airflow. Clean out bagless dust compartment and HEPA filter. Allow the appliance to cool down for 1 hour before reuse.
Move and transporting the appliance:
Caution:
A special handle is provided with this appliance which will enable you to move and transport this appliance comfortably. There is also a specially designed grip handle on the bagless dust compart- ment to move or transport the appliance. Please note: Do not use the grip handle of the bagless dust compartment to move or transport the appliance. This can cause damage to the compartment as well as cause the appliance to malfunction.
(Fig. 4)
Cleaning the HEPA filter:
Warning:
Before any cleaning is done, please ensure that the appliance is switched off and that the appliance plug is removed from the socket.
1.Press the release button of the bagless dust compartment, found on the dust grip handle. Remove the bagless dust compartment from the appliance. Release the button of the ba- gless dust compartment once compartment has been fully removed.
2.Once the compartment has been removed, open the hatch of the compartment to empty all
dust and dirt as shown in Fig. 6.
(It is essential to empty bagless dust compartment once dust level reaches maximum capacity. Also re- move HEPA filter and clean separately.)
2010/11/22 08:35:50 AM
