Assembly Instructions
Read the entire Important Safety Information section at the beginning of this document including all text under subheadings therein before set up or use of this product.
The Hydraulic Lift Table requires some assembly after you unpack it.
Front
Wheels
(47)
Lock Nuts (14)
Washer (15) 
Bushing (48)
Hex Bolts (16)
Figure 1
1.First, set aside the hardware needed to install the Front Wheels (47). The hardware includes the Hex Bolts (16), Lock Nuts (14), Washers (15), and Bushings (48).
Wrench
Washer (15)
Wheel
Frame
Front Wheel
(47)
Lock Nut (14)
Figure 2
2.Turn Lift Table on its side. Slide Bushing through center hole in the Front Wheel. Then set Front Wheel in the wheel frame of the Base Assembly (17). Slide the Hex Bolt through the Washer, wheel frame and Bushing. Use a wrench (sold separately) to fasten Lock Nut onto Hex Bolts, until the Front Wheel is secured into place.
Lifting Pedal
Connector
(30a)
|
| Lifting |
| Bolt (29) |
|
| Pedal |
|
|
|
|
|
| |
Wrench | (27) |
|
| |
Figure 3
3.Slide Lifting Pedal (27) into Pedal Connector (30a), aligning the installation holes. Then slide the Bolt (29) through the Washer (15) and through the installation holes. Use the wrench to fasten the Lock Nut (12) over the Bolt, securing Lifting Pedal in place. See Figure 3.
|
|
| Handle | |
|
| (21) | ||
|
| |||
|
|
|
| |
Wrench |
|
| ||
| Bolt (20) |
| Base | |
|
| |||
Figure 4 |
| Assembly | ||
(17) | ||||
|
| |||
4.Slide the ends of the Handle (21) into the handle slots on the Base Assembly (17). Use the wrench to tighten the Bolts (20) until Handle is securely fastened in place. See Figure 4.
5.WARNING! After assembly, try out the Lift Table to make sure it is functioning properly before using it to lift a load.
Page 2 | For technical questions, please call | SKU 94822 |
