Operating Instructions
1.Before loading and while stationary, lock the back Casters (19) to prevent the Lift Table from moving.
2.The Table (1) is raised by pumping the Lifting Pedal (27) with your foot until the desired height is achieved.
3.Once desired height is reached, swing down the Safety Bars (7) on either side of the Lift Frame. This will prevent any kind of uncontrolled Table drop.
4.To lower the Table, Squeeze the Release Handle (22) at the top of the main Handle.
Note: Be sure to lift Safety Bars up, allowing the Table to be completely lowered (if needed).
Maintenance
1.Lubricate hydraulic connections monthly with a good quality grease.
2.Check for the free movement and wear of the wheels. Replace if needed.
3.Check the Caster brakes regularly. They should lock firmly and release completely.
4.If you encounter difficulty using the Release
Handle to lower the Table, the Control Cable (49) may need adjusting.
WARNING! Make sure the Release Handle is pressed only halfway down during adjustment. This will allow the Table to lower slowly for safety purposes.
a. With assistance, tip over Lift Table.
Hex Bolt (16) | Cable Bolt (50) |
Control Cable (49) |
Figure 5
b.Loosen the Cable Bolt (50) and Cable Nut (51) and tug the Control Cable until it is tight. WARNING! Do not pull too tight; you want to leave a small amount of give. See Figure 5.
c.
5.Check for oil leakage from the hydraulic cylinder. The hydraulic cylinder is not user serviceable.
WARNING! Any service or repairs to the Hydraulic Lift Table should be performed by a qualified service technician. Improper repairs or service could result in equipment failure or personal injury.
Bleeding Instructions
If the Lift Table is not performing properly, it may be due to air in the hydraulic system. Follow these steps to bleed air from the system.
1.Raise the Table to it’s highest position.
2.Swing down the two Safety Bars so that they both rest on the top platform of the Base Assembly.
3.Remove the rubber Oil Plug (J04). You can carefully remove it with a large flat head screwdriver.
4.After the Oil Plug is removed, swing the two Safety Bars back against their stops.
5.Squeeze the Release Handle to lower the Table. This should purge the air out of the hydraulic system.
6.Raise the Table to it’s highest position and swing both the Safety Bars down onto the Base Assembly (17).
7.Top off hydraulic fluid into the oil hole where the Oil Plug goes until it is full. Note: Make sure you use new oil.
8.Replace the Oil Plug by firmly pressing it in while twisting it.
SKU 94822 | For technical questions, please call | Page 3 |
