Memorex MP3134BLU manual Safety Instructions

SAFETY INSTRUCTIONS (CONTINUED)
15. OVERLOADING
Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.
16. OBJECT AND LIQUID ENTRY
Never push objects of any kind into this product through openings as they may touch dangerous voltage points
or short out parts that could result in fire or electric shock. Never spill or spray any type of liquid on the product.
17. OUTDOOR ANTENNA GROUNDING
If an outside antenna is connected to the product, be sure the antenna system is grounded so as to pro-
vide some protection against voltage surges and built-up static charges. Section 810 of the National
Electric Code, ANSI/NFPA 70, provides information with respect to proper grounding of the mast and sup-
porting structure, grounding of the lead-in wire to an antenna discharge product, size of grounding conduc-
tors, location of antenna discharge product, connection to grounding electrodes and requirements for
grounding electrode.
18. SERVICING
Do not attempt to service this					ANTENNA
product yourself as opening or					LEAD IN
					WIRE
removing covers may expose you
to dangerous voltage or other		GROUND
hazards. Refer all servicing to		CLAMP
qualified service personnel.					ANTENNA
					DISCHARGE UNIT
19. REPLACEMENT PARTS					(NEC SECTION 810-20)
When replacement parts are
required, be sure the service tech-	ELECTRIC
	SERVICE				GROUNDING CONDUCTORS
nician uses replacement parts	EQUIPMENT				(NEC SECTION 810-21)
specified by the manufacturer or				GROUND CLAMPS
those that have the same charac-			POWER SERVICE GROUNDING
	NEC - NATIONAL ELECTRICAL CODE		ELECTRODE SYSTEM
			(NEC ART 250, PART H)
teristics as the original part.	S2898A
Unauthorized substitutions may
result in fire, electric shock or	EXAMPLE OF ANTENNA GROUNDING AS PER
other hazards.
20. SAFETY CHECK	NATIONAL ELECTRICAL CODE

Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

21. WALL OR CEILING MOUNTING

The product should be mounted to a wall or ceiling only as recommended by the manufacturer.

22. DAMAGE REQUIRING SERVICE

Unplug the product from the wall outlet and refer servicing to qualified service personnel under the follow- ing conditions:

a. When the power-supply cord or plug is damaged.

b. If liquid has been spilled or objects have fallen into the product. c. If the product has been exposed to rain or water.

d. If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, as an adjustment o other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation.

e. If the product has been dropped or the cabinet has been damaged. f. When the product exhibits a distinct change in performance–this

indicates a need for service.

23. HEAT

The product should be situated away from heat sources such as radiators, heat registers, stoves or other products (including amplifiers) that produce heat.

24. NOTE TO CATV SYSTEM INSTALLER

This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be con- nected to the grounding system of the building, as close to the point of cable entry as practical.

5