Safety Check, Wall or Ceiling Mounting, Heat | Memorex MVT2195B

21.SAFETY CHECK

Upon completion of any service or repairs to this unit, ask the service technician to perform safety checks to determine that the unit is in proper operating condition.

22.WALL OR CEILING MOUNTING

The product should be mounted to a wall or ceiling only as recommended by the manufacturer.

23.HEAT

The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.

24.NOTE TO CATV SYSTEM INSTALLER

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

EXAMPLE OF ANTENNA GROUNDING AS PER THE

NATIONAL ELECTRICAL CODE

		ANTENNA
		LEAD IN
		WIRE
	GROUND
	CLAMP
		ANTENNA
		DISCHARGE UNIT
		(NEC SECTION 810-20)
	ELECTRIC
	SERVICE	GROUNDING CONDUCTORS
	EQUIPMENT	GROUNDING CONDUCTORS
	EQUIPMENT	(NEC SECTION 810-21)
		(NEC SECTION 810-21)
		GROUND CLAMPS
	NEC-NATIONAL ELECTRICAL CODE	POWER SERVICE GROUNDING
	NEC-NATIONAL ELECTRICAL CODE	ELECTRODE SYSTEM
		(NEC ART 250, PART H)

S2898A

ENGLISH

3

545A201A-E/P01-09

3

19*04*0, 17*19

Image 5

Memorex MVT2195B, MVT2135B owner manual Safety Check, Wall or Ceiling Mounting, Heat, NEC Section

Contents

MVT2135B MVT2195B English Accessories CleaningPower Sources Read Instructions Power Lines POWER-CORD ProtectionDamage Requiring Service Replacement Parts Wall or Ceiling Mounting Safety CheckHeat NEC Section Features Table of Contents When YOU Experience the Above Conditions PrecautionsMoisture Condensation Moisture will Condense on the Unit in the Following Cases AC Outlet Power SourceTo USE AC Power Source Power Indicator Lights when the power is turned on AC Power Cord Connect to a 120V, 60Hz outletLocation of Controls Cassette Loading Slot To insert or remove a video tape Menu Remote Control Battery compartment Polarity diagramArrow Paying attention to Combiner UHF 300 ohm VHF 300 ohm Antenna ConnectionsMatching Indoor Antenna Cable TV Connections For Subscribers to Basic Cable TV ServiceFor Subscribers to Scrambled Cable TV Service Normal TV viewing Setting the LanguageEnter button Auto Clock Setting Auto Clock SettingAuto Clock Adjustment To SET Auto Clock to OFF Press the Menu button until the Menu screen is cleared Press the Menu button. Press the SETPress the Enter button Example Setting the clock to 830 AM, 23rd. MON October Manual Clock SettingTo move cursor backward, press the Cancel button Press the SET/TRACKING TV Operation Adjust the volume level byTo turn on the TV/VCR VHF/UHF Channels Call MutingChannel + Quick View SleepTV/CAPTION/TEXT To View Closed Captions What is Closed CAPTIONING?Closed Captioning with a VCR To Memorize Channels TV/CATV modeSelected mode Screen is cleared Automatic Memory TuningChannels available in your area Or Channel + or button Using SET/TRACKING + orTo ADD/DELETE Channels To Register Password Setting the V-CHIPEnter the same password Again for the safety, then To SET the V-CHIP All ages Movie Rating is not setPG-13 Parental guidance Less than 13 years old Under 17 years old To Change Password + or button to set To SET the on TimerDesired hour, then press the Enter button Set the desired minute Example Turning off the TV at 1130 PM To SET the OFF Timer Brightness Picture Control AdjustmentsContrast Menu button Button to adjust the sharpness of the picture Preset levels Sharpness CancelColor Tint Press the Enter button until Sharpness appears Loading and Unloading a Video Cassette Automatic Power on and PlayLoading Unloading Tape Speed and Maximum Playback / Recording Time To Prevent Accidental Erasure To Record Again To Start Playback PlaybackTo Stop Playback To play a prerecorded tape FORWARD/REVERSE Picture Search To Rewind or Forward the Tape RapidlyDigital Tracki NG Control To Visually Search for Desired Points Special PlaybackSpeed Search Times Skip Search To Watch Still Picture To Watch a Tape Repeatedly Repeat mode is canceledSelect the Auto Repeat option Position Recording and Viewing the Same TV Program Recording a TV Program To Stop Recording To Stop Recording Temporarily Screen and the Rec/Otr indicator will lightTo be recorded. Example Channel Press the REC/OTR button TV/VCR channel cannot be changed during recording ONE-TOUCH Timer Recording OTR Check the Timer REC SET option is selected Timer RecordingThen press the Enter button Select the Program position, then press Indicator will light. The Timer is programmed To set the timer for another program, pressWhen the programmed time is reached, Recording is automatically started To SET DAILY/WEEKLY Timer Other Functions for the Timer RecordingTo Confirm the Settings Example Program Deleted Parts Recording Prog.1 Prog.2 Prog.3 Control Settings To View the Counter Display Using the Real Time Tape CounterTape Counter Counter to Using Zero Return Connection to Another VCR Duplicating a Video TapeConnection to Camcorder Tion tab intact into the TV/VCR Ignition Reception Disturbances Symptoms Cause Possible Solutions Power Troubleshooting GuideNo power TV Broadcast Reception Remote Control Symptoms Cause Possible SolutionsRecording Playback Snowy Picture Video Head Cleaning Accessories SpecificationsTelevision VCR Memo Español 545A201A K 00/03