Memorex MX4118 manual Speaker Connection, Headphone Jack, Battery Operation for the Remote Control

AC Outlet

SPEAKER CONNECTION

Locate the Speaker Jacks on the rear of the unit and connect the right speaker to the Right (R) Speaker jack and the left speaker to the Left (L) Speaker jack.

CAUTION: Only connect the speakers which are supplied with the unit. The use of any other or additional speakers may cause damage to the unit. Never operate the unit without the speakers connected.

HEADPHONE JACK

To listen to the unit through headphones, simply insert headphones (not included) into the Headphone jack. The speakers will be disconnected when the headphones are plugged in.

BATTERY OPERATION FOR THE REMOTE CONTROL

The battery compartment is located on the rear of the remote control.

• Remove the battery compartment door by pressing in on the tab and lifting the battery compartment door off.

• Insert two (2) AAA size batteries into the battery compartment as shown to the right. Be sure to observe the polarity markings which are engraved inside the battery compartment. If the batteries are inserted incorrectly, the remote control will not operate.

• Replace the battery compartment door.

BATTERY PRECAUTIONS

Follow these precautions when using batteries in this device:

1. Use only the size and type of batteries specified (alkaline are recommended).

2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries may cause damage to the device.

3. Do not mix different types of batteries together (e.g. Alkaline, Carbon-zinc or rechargeable) or old batteries with fresh ones.

4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.

5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer’s directions.)

AC CONNECTION

Unwind the AC cord and extend it to its full length. Insert the AC plug into any convenient 120V 60Hz household outlet.

Please note that this unit is equipped with a polarized AC plug which has one blade wider than the other. This is a safety feature to reduce the likelihood of electric shock. This polarized AC plug will only fit in a polarized AC outlet. If

you find that you cannot insert this plug into your outlet, you may have an AC Plug

obsolete non-polarized outlet. Please do not try to defeat this safety feature by using a non-polarized adapter or by filing the wider blade to make it fit into your outlet. If this plug does not fit into your outlet, you should contact a qualified licensed electrician to replace your obsolete outlet.

IMPORTANT NOTES:

• Before moving or lifting the unit, make sure the power plug is disconnected from the power source.

• If there is a power failure or the AC cord is disconnected, when the power is resumed or the AC cord is connected again. The clock will be reset ("12:00" will appear on the display) and you will need to set it again. However, the Radio Preset stations will be kept although there is a power failure or you disconnected the AC cord.

4