PROPELLER INSTALLATION INSTRUCTIONS
3.Install the aft washer onto the drive sleeve assembly and lightly tap the drive sleeve assembly into the propeller. The aft washer will contact the propeller when the drive sleeve assembly is properly seated.
a - Aft washer
a
43668
IMPORTANT: The Flo‑Torq Reflex drive hub requires the use of the thrust washer that is included with the drive hub kit.
Mercury Outboard Application
1.Install the thrust washer onto the propeller shaft.
43671
2.Install the propeller.
3.Install the aft washer, the tab washer, and secure with the propeller nut included with the kit. Tighten the nut to the specified torque. Bend the tabs on the tab washer onto the nut.
IMPORTANT: The Flo‑Torq Reflex drive hub requires the use of the propeller nut included with the drive hub kit. The use of a propeller nut that was not included with the Flo‑Torq Reflex drive hub kit will result with the nylon portion of the locknut not fully engaging the propeller shaft threads.
a | b | c d |
|
| |
|
| e |
a - Thrust washer (Mercury/Yamaha) b - Propeller
c - Aft washer d - Tab washer e - Nut
43652
4.Rotate the propeller to verify interference or binding does not exist between the gear housing and the propeller.
Description
Nut
NOTE: A small amount of rotation play and forward aft play is normal.
Nm
74.6
lb‑in.
lb‑ft
55
Honda and Yamaha Outboard Application
1.Install the correct thrust washer onto the propeller shaft.
a |
|
|
|
| b | a - | Yamaha application | ||
|
|
| |||||||
|
|
|
|
|
|
|
| b - | Honda application |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
43672
2.Install the propeller.
Page 4 / 7 |
