Meridian Audio 568 manual To connect an active subwoofer eg Meridian M1500 or M2500

Setting up the digital surround processor

To connect an active subwoofer (eg Meridian M1500 or M2500)

568 Digital Surround Processor	Subwoofer
4	DIRECT	CROSSOVER
	INPUT	INPUT

SUB

Audio lead

●Connect the SUB analogue output socket from the 568 Digital Surround Processor to the subwoofer’s line level input.

The digital surround processor provides very high-quality crossovers for the subwoofer, and for best results you should use these instead of the subwoofer’s crossover. To do this set the subwoofer filtering to Narrow, and remove any crossover in the subwoofer or set it to its highest setting (eg 200Hz). If you cannot do this set the subwoofer filtering to wide to switch off the digital surround processor’s crossover and use Sine/Sub mode to match the subwoofer’s crossover frequency. For more information see Subwoofers, page 87.

If you are using an M1500 or M2500 use the L+ input and configure it for Bypass; refer to the subwoofer’s user guide for more information.

58