Manuals
/
Mesa/Boogie
/
Home Audio
/
Stereo Amplifier
Mesa/Boogie
M6 owner manual 04/30/08
Models:
M6
1
20
20
Download
20 pages
55.2 Kb
13
14
15
16
17
18
19
20
<
>
Factory Sample Settings
Precautions & Warnings
Mosfet Power
Page 20
Image 20
®
04/30/08
Page 19
Page 20
Image 20
Page 19
Contents
Page
Greetings from the Home of Tone
CONTROLS
Table of Contents
Precautions
FRONT PANEL
PRECAUTIONS & WARNINGS
READ AND FOLLOW INSTRUCTIONS OF PROPER USAGE
Operating Instructions
Overview
FRONT VIEW M6 CARBINE
REAR VIEW M6 CARBINE
Overview Continued
PAGE
FRONT PANEL CONTROLS
FRONT PANEL CONTROLS Continued
FRONT PANEL CONTROLS Continued
Here is a synopsis of the 5 choices found on the VOICE control
FRONT PANEL CONTROLS Continued
PULL-MUTE
Page
REAR PANEL CONTROLS
REAR VIEW M6 CARBINE
REAR PANEL CONTROLS Continued
XLR jack and 2 a GROUND LIFT switch
REAR PANEL CONTROLS Continued
To use the EFFECTS LOOP
1Connect the SEND jack to your processor’s Input
FACTORY SAMPLE SETTINGS
MOSFET POWER
MOSFET POWER
MOSFET POWER
PERSONAL SETTINGS SHEET
MOSFET POWER
MOSFET POWER
MOSFET POWER
At some point it is quite possible that you will experience some kind of minor pre- amp tube noise. Rest assured - this is no cause for alarm and you can take care of the problem yourself in a matter of minutes by simply swapping tubes. It is always a good idea to keep at least a couple of spare pre-amptubes on hand at all times to insure unin- terrupted performance. These minor pre-amptube problems can take many forms but can generally be described in two categories Noise and Microphonics. Noise can be in the form of crackling, sputtering, white noise/hiss and/or hum. Microphonic problems usually appear in the form of a ringing or high pitched squealing that gets worse as the gain or volume is increased thus are more noticeable in the higher gain “HI” modes. Microphonic problems are easily identified because the problem is still present even with the instru- ments’ volume off or unplugged altogether - unlike pick-upfeedback which ceases as the instrument is turned down. Microphonic noise is caused by mechanical vibration and shock think of banging a microphone around and you’ll understand where the word came from
PAGE
FRONT PANEL
REAR PANEL
Page
04/30/08