Set rip fence to required width of cut. Distance from blade
is shown on the rip fence scale.
Loosen scale fixing screw to adjust rip fence scale to give
exact reading of width of cut.
Make trial cut to verify setting.
Lock rip fence in position by pushing the cam-lock
lever down.
If rip fence is not required it can be hung to the bolt on
the right leg.
-
-
9.3 Rip Fence Setting/Adjusting
Loosen the ratched lever to adjust the blade guard position. Set blade guard about 8mm/3/8“ higher than the
workpiece’s thickness.
Attention! Set blade guard only with blade at complete standstill. Danger of injury!
9.4 Saw Blade Guard
After loosening the starknob on the guard support brak-
ket the complete guard assembly can be removed.
Risk of personal injury when saw is operated wi-
thout blade guard in place!
Attention!
Remove/install blade guard only with blade at
complete standstill.
Danger of injury!