CHEVROLET Camaro 1993-96
4
A
5 |
1
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove
(2)Phillips screws from the top of the driver's side knee bolster. Remove (2) 7mm screws from the bottom of the knee bolster. Open the glove box, remove (3) 7mm screws exposed on the right edge of the radio trim bezel and remove the bezel. Remove (2) 7mm screws securing the left side of the factory head unit and (1) 10mm nut securing the right. Slide the unit from the dash and disconnect the wiring.
2
"A"
Cut and remove all mounting tabs on the Radio Housing EXCEPT tabs "A". The mounting tabs can be identified by the stamped letter on the back of each tab. Skip to the Installation Instructions for ALL VEHICLES on Page #5.
B
C |
D
A)Strip wire ends back ½"
B)Twist ends together
C)Solder
D)Tape
Locate the factory wiring harness in the dash. Metra recommends using the proper mating adaptor and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit).
Fig. A |
Fig. B |
"A" |
"B" |
PONTIAC Bonneville 1994-99
Fig. C
Fig. D |
1
Disconnect the negative battery terminal to prevent an accidental short circuit. Unclip the right side of the dash trim bezel. Unclip the left side of the bezel and remove. Remove (3) 7mm
2 |
"C" |
Cut and remove all mounting tabs on the Radio Housing EXCEPT tabs "C". The mounting tabs can be identified by the stamped letter on the back of each tab. Skip to the Installation Instructions for ALL VEHICLES on Page #5.
FIREBIRD
SUNFIRE:
FIREBIRD 1993, TRANS AM 1993:
CAMARO
1 | 6 |