Wiring Of ASWCSTALK And Interface
1.Connect the BLACK wires of the ASWCSTALK and the BLACK wire of the interface to ground. You may use the same ground point that is used for the radio.
2.Connect the GREEN/ORANGE and BLACK/GREEN wires of the ASWCSTALK to the corresponding wires on the interface.
3.Connect the RED wire to 12 volt accessory
4.Tap off all other unused wires on the interface.
Programming the ASWCSTALK
*If this is the first time the ASWCSTALK is being installed:
1.Turn the ignition on; the led will start flashing rapidly which means the interface is looking for the ASWCSTALK and the radio. Go to step 3.
OR
* If the ASWCSTALK was installed before:
1.Turn the ignition on, the led will flash slowly
2.Hold down the reset button for more then 2 seconds but less then 10 seconds, the led will start flashing rapidly
3.The ASWCSTALK INTERFACE will automatically find the ASWCSTALK and radio.
4.After a couple of seconds the led should stop flashing and not light up for 2 seconds. At this point do not push any buttons.
5.After the 2 seconds there will be a series of 7 flashes, some short and some long.
6.The led will pause for another 2 seconds then flash up to 10 times.
7.This is the end of the auto detection stage. If the ASWCSTALK interface detected the vehicle and the radio successfully the led will light up solid red.
2
