Metra Electronics OESWC-6502-STK installation instructions Troubleshooting the Auto Detect Mode

8.Make sure the steering wheel control buttons function correctly in the vehicle and enjoy your radio.

If the ASWCSTALK is mounted on the right side of the steering column follow the instructions below. (Auto-detect must be done first)

1.Turn the ignition on

2.Press the MODE on the ASWCSTALK for 10 seconds

3.Then press volume up for 2 seconds

4.The ASWCSTALK is now configured for the right side.

Troubleshooting the Auto Detect Mode

So you tried the auto detect feature and at the end the led did not stay on solid red, it started flashing, or the steering wheel controls did not function properly. That means the interface did not detect the ASWCSTALK or the proper radio. Follow these steps to determine what happened:

First some basic tips:

1.Verify that you have 12 volt accessory and a good ground to the ASWCSTALK and interface.

2.Verify that the 3.5mm connector is connected to your radio securely and in the correct location.

3.If using the female 3.5mm connector on an Eclipse or Kenwood radio, verify that the radio’s SWC wire is connected to the correct wire on the interface.

Once all the information above has been verified and correct, you will need to put the interface back into auto-detect mode. Follow the instructions from “If the ASWCSTALK was installed before” section above, however this time take notice of the led flashes in steps 5 and 6.

3