35
DEFAULT SETTINGS – COMMUNICATION PARAMETERS
Many functions of the scanner can be “configured” – that is, enabled or disabled.
The scanner is shipped from the factory configured to a set of default conditions.
The default parameter of the scanner has an asterisk (*) in the charts on the
following pages. If an asterisk is not in the default column then the default setting
is OFF or DISABLED.
PARAMETER DEFAULT PARAMETER DEFAULT
Multi-Try Trigger Out-of-Stand * Data Matrix
Presentation Mode In-Stand * QR Code
Continuous Trigger Maxicode
Single Trigger Aztec
Aiming in
Trigger and Continuous Modes * Postals
Aiming in Presentation Mode Mod 43 Check on Code 39
Long-Range In-Stand * MSI-Plessy 10/10 Check Digit
Short-Range In-Stand MSI-Plessy Mod 10 Check Digit *
Long-Range Out-of-Stand * Paraf Support ITF
Short-Range Out-of-Stand ITF Symbol Lengths Variable
RangeGate Mode Symbol Length Lock None
Inventory Mode Beeper tone Normal
UPC/EAN * Beep/transmit sequence Before
transmit
Code 128 * Communication timeout None
Code 93 * Razzberry tone on timeout
Codabar * Three beeps on timeout
Interleaved 2 of 5 (ITF) * Same symbol rescan timeout:
1000 msecs *
MOD 10 check on ITF
Code 11
Same symbol rescan timeout
configurable in 50 msec steps
(maximum of 6.35 sec.)
Code 39 * No Same symbol timeout
Full ASCII Code 39 Infinite Same symbol timeout
PDF *