Metrologic Instruments MS7100 Quick Start

Quick Start

1.) Plug in the scanner. When the MS7100 is ready to scan,

the red LED will turn on, then the green LED will flash

and the scanner will beep once. (the green LED will

remain on for the duration of the beep).

2.) The scanner is shipped from the factory programmed with

default settings. To configure the MS7100 scanner to meet

the host system’s specific needs, refer to the MetroSelect

Programming Guide (MLPN 2407) for instructions on

how to enter the program mode and to select the appro-

priate bar codes.