Metrologic Instruments MS7600 I NSTALLATION FOR STAND-ALONE KEYBOARD I

Figure 15: Stand-Alone

Keyboard Interface

INSTALLATION FOR STAND-ALONE KEYBOARD INTERFACE

1. Turn off the host system.

2. Disconnect the keyboard from the host.

3. Connect the PowerLink cable to the 2nd

jack from the top of the MS7600.

4. Connect the other end of the PowerLink

cable to the keyboard port on the host.

Before continuing verify that the

PowerLink cable is connected to the

appropriate interface jack on the

scanner. An incorrect cable connection

can cause communication problems or

potential damage to the scanner.

5. Connect the external power supply

to the power jack on the PowerLink

cable.

6. Check the AC input requirements

of the power supply to make sure

the voltage matches the AC outlet.

7. Connect AC power to the transformer.

The outlet should be near the equipment

and easily accessible.

8. Scan the Load Keyboard Wedge

Defaults bar code then the

Enable Stand Alone Keyboard bar code

to configure the MS7600 for Stand-Alone

Keyboard communication.

Note: When scanning the bar codes,

cover the code not being scanned

to ensure the codes are read in

the proper sequence.

9. Turn on the host system.

Caution:

To maintain compliance with applicable standards, all circuits connected to the scanner must meet the

requirements for SELV (Safety Extra Low Voltage) according to EN 60950.

To maintain compliance with standard CSA C22.2 No. 60950-00/UL 60950 and norm EN 60950, the power

source should meet applicable performance requirements for a limited power source.

³999994

Scan 1

Load Keyboard

Wedge Defaults

³5155153

Scan 2n

Enable Stand-Alone

Keyboard