14
Figure 19: RS232/IBM, Interface
INSTALLATION FOR IBM 46XX INTERFACE
1. Turn off the host system.
2. Connect the MVC cable to the
1st jack down from the top of
the MS7600.
3. Connect the other end of the
MVC cable to the host.
Before continuing verify that the
MVC cable is connected to the
appropriate interface jack on the
scanner. An incorrect cable
connection can cause
communication problems or
potential damage to the scanner.
Manufacturers Note:
Plugging the scanner into the
serial port of the PC does not
guarantee that scanned
information will appear at the PC.
A software driver and correct
configuration setting are also
required for proper
communication to occur.
4. Turn on the host system.
5. Scan the Load 46xx IBM Defaults
bar code to configure the
MS7600 for IBM 46xx
communication.
For additional communication options for IBM interfaces refer to the MetroSelect
Programming Guide (MLPN 00-02407B).
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must meet the
requirements for SELV (Safety Extra Low Voltage) according to EN 60950.
To maintain compliance with standard CSA C22.2 No. 60950-00/UL 60950 and norm EN 60950, the power
source should meet applicable performance requirements for a limited power source.
³999995
Load 46xx IBM Defaults