4
OPERATIONAL TEST1. Connect the 10-pin RJ45 male
connector into the jack on the
Voyager or VoyagerCG. You
will hear a ‘click’ when the
connection is made.
2. Connect the L-shaped plug
of the power supply into the
power jack on the PowerLink
cable.
3. Connect the power supply into
an AC outlet. Make sure the
AC input requirements of the
power supply match the AC
outlet.
4. When the Voyager is ready to
scan, the green LED will turn
on, the red LED will flash and
the scanner will beep once.
5. Place a bar code in front of
the scanning window. The
scanner will beep once and
flash the red LED if the bar
code was successfully
decoded and transmitted
(default mode only). For the
MS9540, press the CodeGate
button to transmit the data.
All Voyager’s are shipped configured with a set of factory defaults. Refer to
the MetroSelect Configuration Guide or MetroSet®2’s help files for
instructions on how to configure the scanner.
Caution:
To maintain compliance with applicable standards, all circuits con nected to the scanner must
meet the requirements for SELV (Safety Extra Low Voltage) according to EN 60950.
To maintain compliance with standard CSA C22.2 No. 950/UL 1 950 and norm EN 60950, the
power source should meet applicable performance requirement s for a limited power source.
Figure 1.
Figure 2.
Figure 3.