9
THE POWERLINK CABLE
DISCONNECTING THE POWERLINK CABLE
Before removing the cable from the scanner, Metrologic recommends that the
power on the host system is off and the power supply has been disconnected
from the PowerLink cable.
Figure 8.
1. Locate the small ‘pin-hole’ on the top of the unit near the bottom of the
Voyager logo.
2. Bend an ordinary paperclip into the shape shown above.
3. Insert the paperclip (or other small metallic pin) into the small ‘pin-hole’.
4. You will here a faint ‘click’. Pull gently on the strain-relief of the PowerLink
cable and it will slide out of the scanner.
CONNECTING THE POWERLINK CABLE
Important: If the PowerLink cable is not fully latched the unit can power
intermittently.
Figure 9a. Figure 9b.