Metrologic Instruments MS9524 D ISCONNECTING THE P OWER L INK C, C ONNECTING THE P OWER L INK C

9
DISCONNECTING THE POWERLINK CABLE
Before removing the cable from the scanner, Metrologic recommends that the
power on the host system is off and the power supply has been disconnected
from the PowerLink cable.
Figure 8.
1. Locate th e small ‘pin-hole’ on the top of the unit near the bottom of the
Voyager logo.
2. Bend a n ordinary paperclip into the shape shown above.
3. Insert the pap erclip (or other small metallic pin) into the small ‘pin-hole’.
4. You will here a faint ‘click’. Pull gently on the strain-relief of the PowerLink
cable and it will slide out of the scanner.
CONNECTING THE POWERLINK CABLE
Important: If the PowerLink cable is not fully 'latched' the unit
can power intermittently.
Figure 9b.Figure 9a.