37
DEFAULT SETTINGS
Many functions of the scanner can be “programmed” – that is, enabled or
disabled. The scanner is shipped from the factory programmed to a set of
default conditions. The default parameter of the scanner has an asterisk (*) in
the charts on the following pages. If an asterisk is not in the default column then
the default setting is OFF or DISABLED. Every communication does not support
every parameter. If the communication supports a parameter listed in the charts
on the following pages, a check mark will appear.
PARAMETER DEFAULT OCIA RS-232 LIGHT
PEN
IBM
46XX KBW USB LASER
EMULATION
Normal Scan Mode *9 9 9 9 9 9 9
Continuous Scan Mode 9 9 9 9 9 9 9
Blinky Scan 9 9 9 9 9 9 9
Continuous Blinky Scan 9 9 9 9 9 9 9
Custom (one shot) Scan 9 9 9 9 9 9 9
Long-Range In-Stand *9 9 9 9 9 9 9
Short-Range In-Stand 9 9 9 9 9 9 9
Long-Range Out-of-Stand *9 9 9 9 9 9 9
Short-Range Out-of-Stand 9 9 9 9 9 9 9
CodeGate Active In-Stand 9 9 9 9 9 9 9
CodeGate Inactive In-Stand *9 9 9 9 9 9 9
CodeGate Active
Out-of Stand *9 9 9 9 9 9 9
CodeGate Inactive
Out-of Stand 9 9 9 9 9 9 9
UPC/EAN *9 9 9 9 9 9 9
Code 128 *9 9 9 9 9 9 9
Code 93 *9 9 9 9 9 9 9
Codabar *9 9 9 9 9 9 9
Interleaved 2 of 5 (ITF) *9 9 9 9 9 9 9
MOD 10 check on ITF 9 9 9 9 9 9 9
Code 11 9 9 9 9 9 9 9
Code 39 *9 9 9 9 9 9 9
Full ASCII Code 39 9 9 9 9 9 9 9
PDF *9 9 9 9 9 9 9
PDF CodeGate Active
Out-of-Stand 9 9 9 9 9 9 9