Metrologic Instruments MX003 manual Appendix B, Default Settings of the MS6130 and MX Receiver

APPENDIX B

Default Settings of the MS6130 and “MX” Receiver

Before the MS6130 hand-held scanner and “MX” Receiver ships from the factory, the factory programs the scanners to a group of default settings. An asterisk ( * ) in the charts on the following pages marks the default settings of the units. If an asterisk is not in the default column then the default setting is Off or Disabled.

The MS6130 and “MX” receiver do not support every parameter. For those parameters that are a transmitter function, a letter “T” will appear in the second column of the charts, for the “MX”, the

letter “R”.

RS-232, light pen and keyboard wedge emulation does not support every parameter. If your host device’s communication supports a parameter listed in the charts on the following pages, a check mark will appear.

In order for the “MX” receiver to communicate with your RS-232, light pen or keyboard wedge host device properly, program it to meet your individual scanning needs. Since each host system is unique, change the default settings to match your host system requirements. To modify default settings, refer to the MS4120 and MS951 Programming Guides.

Note: If your “MX” Interface is connected to a MS700i/MS720i scanner, use the bar codes in the ScanSelect Programming Guide to match your scanner’s settings to the host system requirements.

T - Transmitter (MS6130 Hand-held)

R - Receiver (“MX”)

Parameter	T - Transmitter	Default	RS-232	Light
	R - Receiver			Pen
Enter/Exit Program Mode	T
Recall Defaults	R
Enter Program Mode After Any
Scan	T	*	3	3
Enter Program Mode Only on
First Scan	T		3	3
Short Range Activation Out of the
Stand	T		3	3
Long Range Activation Out of the
Stand	T	*	3	3
Short Range Activation in the
Stand	T		3	3

32