3. Operation
3.4 Personalisation (optional)
Function
Personalisation parameters can be set and modified using the UPS Driver software installed on a computer that is connected to the UPS (see section 2.4 Connection to the RS232 communications port).
Check that the RS232 30 cable is properly connected.
UPS Driver installation:
1 - Insert the
3 - Run "\Emb\Config\UPSDRVxx.exe", where xx is the software version.
It is also possible to download the UPS Driver software from the www.mgeups.com site.
Once the UPS Driver software has been installed, the parameters listed below can be modified.
"ON / OFF conditions" tab
Personalisable function | Default setting | Options |
|
|
|
Automatic start | Enabled | Disabled |
|
|
|
Cold start (battery power) | Enabled | Disabled |
|
|
|
Forced shutdown | Enabled | Disabled |
|
|
|
Sleep mode | Disabled | Enabled |
|
|
|
UPS ON / OFF via software | Enabled | Disabled |
|
|
|
"Battery" tab
Personalisable function | Default setting | Options |
|
|
|
|
| Once a day |
Automatic "Battery test" intervals | Every weeks | Once a month |
|
| No test |
|
|
|
20% remaining battery backup time | From 0% to 100% of the remaining | |
|
| battery backup time |
|
|
|
Protection against deep discharges | Enabled | Disabled |
|
|
|
34007532EN/AA - Page 17