Microboards Technology LLC
Setting up the CWR-424-52 duplicator
Set up the
•19” Rack mount position or
•On a level and stable surface
•In a well ventilated location
•Temperature and humidity:
oTemperature:
oHumidity:
Do not locate the
Under direct sunlight (If the machine is exposed to sunlight, the light should be blocked by a curtain or blind.)
In a place where there is a lot of vibration Near open flame
In a place where the temperature and humidity change drastically Near a heating device such as a heater or furnace
In a location where air from an air conditioner blows directly onto the unit Near a container filled with water such as a vase
In a dusty location
oDust and dirt can decrease the productivity of the duplicator dramatically. It is very important to keep the system in a clean and dust free environment.
In winter during times of low humidity or in a location where static electricity is generated, use an
Copy Process
The advantage of the
Turn on
oThe LED’s turn on, one at a time and then go off, leaving the 1st mode light on. o Insert a Master disc into the Master drive and blank discs into writers.
o Wait for ten seconds until the drives are ready. o Press the ‘START’ button (press it once).
o The copy process begins.
Refer to the “LED’s Status” and “Copy Mode Process” sections for details.
Using Audio Masters:
When copying Audio masters with a large number of tracks, the system can take 3 to 5 minutes to
4