DVD Premium Pro LightScribe Series | MICROBOARDS TECHNOLOGY, LLC |
Installation Requirements
System Setup
•Connect the power cable to the DVD Premium Pro Series tower and plug in to a protected power outlet strip or UPS power supply.
•NET Series Only: Connect the 2 towers using the NET cable provided (see page 7 for
more information).
oThe left port on the back is the IN port, and the right is the OUT port; the Master
tower should have the NET cable plugged into the OUT port, and the Slave should have the cable plugged into the IN port.
oIf more than 2 towers are being connected, connect the OUT port in the first Slave to the IN port of the next. In the final chain of towers, the Master wil have only the OUT port used, while the final tower will have only the IN port used.
•Turn on power to the tower. The system is now ready to use. If you have a NET Series system, you will need to configure the system before proceeding (see page 8).
Install your DVD Premium Pro Series duplicator in the following environment:
•On a level and stable surface
•In a well ventilated location
•Temperature and humidity
•Temperature:
•Humidity:
Do not install it in the following places:
Under direct sunlight (If the machine is exposed to sunlight, the light should be blocked by a curtain or blind.)
A dusty location
A place where there is a lot of vibration
Near open flame
A place where the temperature and humidity change drastically
Near a heating device such as a heater or furnace
A location where air from an air conditioner blows directly onto the unit
Near a container filled with water
In winter during times of low humidity or in a location where static electricity is
generated, use an
Power supply
Use house current as the power source for the unit.
Do not use an outlet near a motor driven appliance (i.e. air conditioner, copying machine).
Use an outlet with stable power supply voltages.
Do not overload an outlet. Do not use a service outlet from a PCs or other office machine.
Wire the power cord properly.
Do not touch the power cord with a wet hand.
Be careful not to damage the power cord.
Inspect the power cord periodically.
In the event that the power cord is damaged, replace the power cord.
Be sure to use a tool such as a screwdriver to change the 115/230V Switch. Do not use your finger.
6
