Micronics M5Pi System Board Manual

Installation of the M5Pi

The installation of the M5Pi system board depends on the type of case you use. The M5Pi is a Baby AT size system board and you should be able to install it in most cases.

Prior to installing the M5Pi, make sure you have a clear work space available and adhere to all anti-static precautions.

If you are unfamiliar with installing a system board, Micronics highly recommends you read the computer user’s manual or contact your dealer’s technical support department.

Tools Required

Micronics recommends using the following tools to install the M5Pi:

mSmall Phillips screwdriver.

mTweezers or a pair of needle-nose pliers.

mTray (to hold loose screws).

Equipment Required

Micronics recommends using the following equipment with the M5Pi for a typical configuration:

mChassis with standard hardware.

mA high quality power supply capable of providing continuous power within a 5 volt range, plus or minus 5% (eg. 4.75 to 5.25). A power filter may be used with a noisy AC power source..

mPS/2 compatible keyboard (PS/2 version).

mAT-compatible keyboard (AT version).

mEight ohm speaker (included with most chassis).

mStandard ribbon cables for internal connections.

mStandard power cord (grounded).

mHeat sink with cooling fan (required).

3-2