Microsoft manual 32 PXP43 Motherboard User’s Guide, Power Management Setup

32PXP43 Motherboard User’s Guide

Power Management Setup

This page sets up some parameters for system power management operation.

CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.

Power Management Setup

					Help Item
ACPI Suspend Type			S3 (STR)
Soft-off by PWR-BTTN			Instant Off
					Select the ACPI
PWRON After PWR-Fail			Power Off
Resume by Ring			Disabled		state used for
Resume By PCI/PCI-E/Lan PME			Disabled		System Suspend.
Resume by USB (S3)			Disabled
Resume By PS2 KB (S3)			Disabled
Resume By PS2 MS (S3)			Disabled
Resume on RTC Alarm			Disabled
mn< >	:Move Enter : Select	+/-/: Value		F10: Save	ESC: Exit
	F1: General Help	F9: Load Default settings

ACPI Suspend Type (S3)

Use this item to define how your system suspends. In the default, S3, the suspend mode is a suspend to RAM, i.e, the system shuts down with the exception of a refresh current to the system memory.

Soft-off by PWR-BTTN (Instant off)

Under ACPI (Advanced Configuration and Power management Interface) you can create a software power down. In a software power down, the system can be resumed by Wake Up Alarms. This item lets you install a software power down that is con- trolled by the power button on your system. If the item is set to Instant-Off, then the power button causes a software power down. If the item is set to Delay 4 Sec, then you have to hold the power button down for four seconds to cause a software power down.

PWRON After PWR-Fail (Power Off)

This item enables your computer to power off, automatically restart or return to its previous status after abnormal power lost.

Resume By Ring (Disabled)

The system can be turned off with a software command. If you enable this item, the system can automatically resume if there is an incoming call on the Modem. You must use an ATX power supply in order to use this feature.

Resume By PCI/PCI-E/Lan PME (Disabled)

The system can be turned off with a software command. If you enable this item, the system can automatically resume if there is an incoming call on the PCI Modem or PCI LAN card. You must use an ATX power supply in order to use this feature. Use this item to do wake-up action if inserting the PCI card.

Resume By USB (S3) (Disabled)

This item allows you to enable/disable the USB device wakeup function from S3 mode.

Using BIOS