HOW TO OPERATE YOUR TRANSCEIVER FOR CB USE
You should become familiar with the controls and complete the preceding installation instructions before attempting operation of your CB.
1.Adjust the squelch control fully
2.Rotate the on/off volume control clockwise to turn the unit on. Adjust the volume for a normal listening level.
3.Select the desired channel by the rotary channel selector. Rotate the squelch control until the background noise is just quieted. You are now in the receive mode.
NOTE: If the channel will not change, check that the “
4.To transmit press the PTT bar on the side of the microphone. Hold the microphone 2 to 3 inches from your lips and speak in a normal voice.
5.To receive simply release the PTT bar.
TO OPERATE YOUR TRANSCEIVER FOR WEATHER RECEIVE
1.Follow steps 1 and 2 above.
2.Press the “WX” button.
3.Using the rotary channel selector select the active channel in your area.
How ESP2™ works to make your CB sound better.
The ESP2™ noise reduction system constantly monitors the signal strength and the type of noise present. When the signal strength is too low for good reception, the receiver sound is automatically adjusted to dramatically reduce the noise that comes through the speaker. While the noise is decreased the actual sounds you need to hear are increased.
Skip interference can cause whistles and howling sounds. Electrical interference from power lines, ignition systems or other sources can produce low humming and buzzing noise. These high and low sounds are not needed for communications. ESP2™ can determine the difference between undesired noises and sounds you want to hear and filter the noises out.
These results ESP2™ can accomplish without decreasing receiver range (it usually increases range). Most importantly, ESP2™ works by itself and does not need to be listening to other ESP2™ equipped CB’s to be 100% effective.
9
