BELT CLIP
LOCK TAB
BELT CLIP LATCH

Model LXT110/80

®

BATTERY INSTALLATION

Your LXT110/80 Series radio operates with 3 AAA alkaline batteries or a NiMH rechargeable battery. The belt clip should be removed to ease installation or removal of the batteries.

To install the batteries:

1.With the back of the radio facing you, remove the belt clip (see diagram below) for easy access, then remove the Battery Cover by pressing down on the top center and sliding it down from the radio.

2.Insert 3 AAA batteries observing the polarity as shown on the Battery Compartment. Installing the batteries incorrectly will prevent the unit from operating or may damage the unit.

3.Return the Battery Cover by sliding it up on the radio. Replace the belt clip,

making sure it locks into place.

BATTERY

COMPARTMENT

BATTERY

COMPARTMENT

COVER

Press here and push down to open

CHARGING THE BATTERY

Your LXT110/80 Series is equipped for using an rechargeable NiMH battery which can be recharged by inserting the AC adapter into the radio charge jack. Initial charge time is 24 hours. Charge time is about 12 hours thereafter. For maximum battery life, we recommend charging the battery when the low battery icon comes on. Remove the radios from the charger when the charge time

!1. Only use our NiMH battery.

2.Do not attempt to charge alkaline batteries or any batteries or battery packs other than the one indicated in the manual. This may cause leakage and damage to the radio.

3.For long term storage of the radio, turn the radio OFF and remove the

batteries from the radio.expires.

EXTERNAL SPEAKER/MICROPHONE JACK

To use an optional speaker / microphone or headset:

Insert the plug(s) into the SPK/MIC jacks

Place the earbud into your ear, and adjust the mic into your desired position.

SPK MIC

CHG

Page 5

 

www.midlandradio.com

Page 5
Image 5
Midland Radio LXT110/80 owner manual Battery Installation, Charging the Battery