EN 11/ PROGRAMMING
EN 12/ CLEANING YOUR APPLIANCE
| C |
|
|
|
|
|
|
BLANCO | 70°C | 65°C | 55°C | 45°C | 45°C |
|
|
|
|
|
|
|
|
| |
A |
|
| B |
| D | E | F |
Fig. 02 |
|
|
|
|
|
|
|
Advice :
Consult the Programmes table on the preceding pages to determine the programme you need for the type of items, the quantity and the amount of food residue.
• CLEANING THE WASTE FILTERS
The filtration system consists of several elements:
A- The waste filter
B- The large main filter
C- The micro filter
The filters are located in the centre of the tub and must be washed regularly to obtain opti- mum washing results.
➀
ABC
➁
•Immediate programme start
Press “On/Off” A , to switch on your appliance and select your programme by pressing one
button 
or the other or the Automatic programme by pressing the “AUTO” button.
—When a programme is selected, the associa- ted light illuminates.
Press “Start/C” F , the “In progress” 
light illuminates. Close the door and the pro- gramme starts.
A short audible signal (beep) confirm the but- ton’s selection, except for the “On/Off” button.
•Delayed programme start
Delay your programme by 1 to 12 hours by keeping on briefly pressing, or holding down, the “Delayed Start” E button, as you prefer. Confirm by pressing “Start/C”.
The screen counts down the hours until the programme starts.
Programme length
Remaining time
End of programme
Waiting for delayed start
Actions :
➀Before removing the filters, remove any waste on the large main filter B with a sponge so that the waste does not block the sprinkler arms. Rotate the spray arm as shown in the drawing. (Fig. 14)
➁Loosen the waste filter a quarter of a turn and then remove it A
③Remove the main filter B
④Remove the micro filter C
⑤Carefully clean filters A , B and C under running water (Fig. 15)
Re-installation:
Proceed in reverse order, inserting filters C and B and then A
Important :
A
③
B
④
C
Fig. 14
⑤
ABC
•Cancelling a programme
Hold down the “Start/C” F button for a few seconds.
•Stopping the appliance
When the programme has finished, press the “On/Off” button A .
Remember to lock the waste filter A in place by pushing it in fully and turning it a quarter turn.
Fig. 15
20 | 21 |
