Miele BFD9XP, BSD9XP manual Summary Of The Faults, Before Calling For Service, Periodically, Advice

EN 12/ CLEANING YOUR APPLIANCE

•Periodically

Every 3 or 4 months, in order to remove any deposits, run a special maintenance programme, with- out any items in the machine, using a special dishwasher cleaning product.

Important :

Keep this product out of children’s reach.

•If not using your dishwasher for a prolonged period:

Clean your dishwasher completely and then unplug it from the electricity supply and close the water tap. Protect your machine from potential frost.

Advice :

Do not use abrasive powders, metal sponges and alcohol-based or thinner-based products. Use a cloth or a sponge.

If you are moving house, run a soaking programme first of all, in order to avoid any water escaping.

EN 13/ IF OPERATING ABNORMALITIES OCCUR

• SUMMARY OF THE FAULTS

Flashing LED(s)			for models without a display			Flashing LED(s)
	d01	: water supply fault (tap)		d07	: overflow / anti-leak fault
	d02	: draining fault		d08	: sprinkling distribution fault
	d03	: heating fault		d11 : pressure sensor fault
	d04 : temperature fault			d12	: filling fault (water inlet
					detection system)
	d05	: faulty motor		d13	: faulty heating
	d06	: faulty motor		d14 : installation fault : (incorrect drainage
				connection or inadequate flow rate and tap).

Tip:

If one of the above faults occurs and you need to call a repair man, remember to tell him the message displayed (d01, d02..) as this information will help him.

• BEFORE CALLING FOR SERVICE

Problem	Possible Causes	What to do?
The door falls heavily when	- Door springs not tensioned	- Tighten the two tensioning
opened (integratable model)	enough to compensate for the	screws accessible in the bot-
	weight of the panel.	tom section above the front
		feet.
The door does not stay horizontal	- Door springs tensioned too	- Loosen the two tensioning
when open or returns too quickly	much.	screws accessible in the bot-
(integratable model)		tom section above the front
		feet.
	- No wooden panel.	- Fit a temporary wooden panel
		on the appliance and adjust
		the springs.
The door catches when closing	- Appliance not stable	- Adjust the feet.
	- Door not centred on the tub	- Re-centre by adjusting the
		rear feet.
The upper basket does not stay	- Poor manipulation (the basket	- Act more progressively (see
in the high position	is being pulled upwards too	instructions), one side and
	quickly)	then the other.
Small leak around or under the	- Leak from the tap.	- Check that a seal is fitted and
appliance (move the appliance	- Leak from the appliance.	retighten the nut.
to locate the leak)		- Close the water tap and call a
	(Cf. table fault d07).	technician.
Small leak at the door	- Appliance not stable or not level	- Adjust the feet.
	- Door not centred on the tub.	- Re-centre by adjusting the rear
		feet.

22 23