Use
Turning on | Regulating the burners |
To turn on the burner, press the control knob down to pass the resistance, then release the pressure and turn it counterclockwise to the largest flame symbol. The ignitor will "click" and ignite the gas.
If the burner does not ignite or the flame goes out, turn the control knob to "". Try again after a few seconds.
If the burner still won't ignite after the second attempt, turn the control knob to "" and see "Frequently asked questions".
Adjust the knob to the desired setting.
The inner and outer burners are both controlled by one control knob. There is a stop at the 6 o’clock position that requires you to press the knob down while turning it, in order to get from the high flame zone to the low flame zone.
To reduce the flames from a high to low setting, turn the control knob counterclockwise until resistance is felt. Press the knob down to pass the stop, then release the pressure and set the combiset to the desired setting.
To increase the flames from a low to high setting, turn the control knob clockwise until resistance is felt. Press the knob down to pass the stop, then let go. Now set the combiset to the desired setting.
Since the outer portion of the flame is much hotter than the center, the flame should be set so that its tips do not spread beyond the sides of the pan. Flames which extend beyond the sides of the pan are hazardous.
Turning off
Turn the knob clockwise to "".
This stops the gas flow and turns off the combiset.
13
