Cleaning and Care
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
Before cleaning or servicing the hood, disconnect it from the power supply, see "Important Safety Instructions".
The halogen bulb is very hot when in use. It will stay hot for some time after turned off. Use caution, danger of burns.
Wet cleaning the hot bulb will cause damage.
Wait a few minutes after turning it off before cleaning.
Cleaning the casing
Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the hood. They will damage the surface.
The exterior surfaces and controls can be cleaned with a mild solution of warm water and liquid dish soap applied with a soft sponge.
Wipe dry using a soft cloth.
Only use a slightly damp sponge when cleaning the controls. Water could penetrate into the electronics and cause damage.
Glass surfaces can be cleaned using glass cleaner.
Avoid:
–cleaning agents containing soda, acids, chlorides or thinners,
–abrasive cleaning agents
e.g. powder or cream cleansers,
–abrasive sponges, e.g. pot scourers or sponges which have been previously used with abrasive cleaning agents,
–limescale removers.
These will damage the surface.
The following instructions for cleaning "Stainless steel" surfaces and "Stainless steel colored controls" should be followed in addition to the general "Cleaning the casing" instructions.
Stainless steel
Stainless steel surfaces can be cleaned using a
To help prevent resoiling, a conditioner for stainless steel can also be used. Apply sparingly with even pressure.
Stainless steel colored controls
These controls may become dis- colored or damaged if not cleaned regularly.
Do not use a stainless steel cleaner on these controls.
13
