Installing the plate warmer
Adhering the insulation strips
^Remove the protective foil from the adhesive strips.
^Align the metal strips flush against the side and rear walls of the cabinet a and stick them on to the plate warmer b (see illustration).
The third metal strip is not needed if the cabinetry does not have a rear panel.
^Install the combination appliance in accordance with its own specific op- erating/installation instructions and then connect the electrical supplies.
Aligning the front of the plate warmer
After installing the combination appli- ance, it may be necessary under cer- tain circumstances to
–align the front of the plate warmer.
–align the gap between the plate warmer and the combination appli- ance.
To help you do this, there are adjusting points underneath the nuts which se- cure the drawer to the telescopic run- ners.
^Loosen the nuts and take the plate warmer drawer out.
Use the adjusters to align the drawer correctly.
17