Before using for the first time
Programming the water softener
Your water hardness level must be programmed into the dishwasher using the buttons on the control panel.
^Make sure the dishwasher is turned off.
^Press and hold the "Start/Stop" button
(17)and at the same time turn on the dishwasher with the "On/Off" button
(13).Release the "Start/Stop" button within two seconds.
The "Rinse" (16) indicator and a program indicator will light and the "Salt" (15) indicator will flash.
If this is not the case, the above steps must be repeated.
If your water hardness is greater than 22 gr/gal (400 ppm) proceed to the next page.
1 - 22 gr/gal:
^Use the program selection buttons (19) to select the program which corresponds to the water hardness in your area.
Table 1
gr/gal* | ppm |
| Program indicator | ||
|
|
|
|
| |
1 - | 4** | 20 - | 70 | Pots & Pans | |
|
|
|
|
|
|
5 | - 7 | 90 | - | 130 | Sani Wash |
|
|
|
|
|
|
8 | - 10 | 140 | - | 180 | Normal Plus |
|
|
|
|
|
|
11 | - 13 | 200 | - | 230 | Normal |
|
|
|
|
|
|
14 | - 16 | 250 | - | 290 | Economy |
|
|
|
|
|
|
17 | - 22 | 310 | - | 400 | Rinse & Hold |
|
|
|
|
|
|
*US gallons
**Factory preset
To store the programmed water hardness:
^Press the "Start/Stop" (17) button twice.
^Turn off the dishwasher.
15